25540502 Driver with Open RS485 protocol for high speed DM40 & DM50 Gimbal Motor
This 12bit encoder and driver is designed for DM40 & DM50 gimbal motor, the commucation RS485 protocol is open code. There is no hole on the encoder magnet. So it cannot support slip ring. The engineer can design and make his own controller for his project.
When you order, please advise us the full motor name, such as DM4010, DM5015 and the KV or wire turns, so that we can match the exact firmware for your motor.
The following is the specifications:
Power: 7.4V - 24V (2S - 6S)
Driving current: 6A
Max Driving current: 8A ( 5S )
Torque closed loop control: Support
Speed closed loop control: Support
Position closed loop control: Support
PWM frequency: 24KHz
Torque closed loop frequency: 24KHz
Torque control bandwidth: 0.4KHz to 2.8KHz
Speed closed loop frequency: 8KHz
Position close loop frequency: 8KHz