BG-8S Battery checker

408268 BG-8S Battery checker

Smart Battery Checker

260,000 color display visible under strong sunlight.
Exquisite and powerful BG-8S smart battery checker
Fully support BattGO technology.

​

Menu Button

Menu Button: Short press to enter setting menu.

long press to enter smart battery menu

When balance port is connected, short press menu twice, BG-8S can initiate cell balancing task.

When connecting to smart battery,in standby press and hold menu button you can go into system setting

Up/Down Button: Go up or down, choose different setting options

Make battery smarter

Cooperating with BattGO technology, only with XT60i connected, you can get full parameters of your battery.
Easy to read cells voltage, battery cycles, working parameters and fast set to your preferred settings.

 

Auto balancing cells voltage

Advanced auto balancing algorithm, make sure every cell is well balanced. After completion auto into low power mode.

 

Powerful portable charging function.

Connecting to your battery, BG-8S can become your power bank for mobile devices.
Support Qualcomm QC 2.0/3.0， compatible with BC1.2 and Apple devices. Maximum output 12V/2A.

 

Receiver signal test and protocol analysis

With standard 3 pin plug, BG-8S can detect BEC output voltage.
BG-8S also supports multiple protocol analysis including PWM, PPM&S.BUS and etc.
With future firmware upgrades more Protocol analysis will be supported.

 

Multiple measurement connections

Support XT60/XT60i, XH2.54 1-8S balance lead, XH 2.54 3pin, JST ETC to measure voltage.
Support LiHv, LiPo, Lilon, LiFe, NiMh/Cd battery and BEC output measurements.

 

Support USB upgrade, multi language options

BG-8S has Micro USB port, More language options are coming soon .

 

XT60i Meant for BattGO

BG-8S uses XT60i connector which was jointly developed by ISDT and Amass, support BattGO technology, and highly compatible with original XT60 plugs.

If current is more than 3A or power is more than 26W it will turn off USB charging.
If temperature is more than 60 °, it will stop charging until temperature is lower than warning
level. It will recharge automatically.
Battery capacity and BattGo mark would appear only smart battery is connected.
Lowest input voltage: For normal battery, if balance port is connected single cell protection voltage
would be displayed as lowest input voltage, without balance port connected battery total
protection voltage would be displayed as lowest input voltage. For smart battery, single cell
protection voltage would be always showed as lowest input voltage.

When balance port is connected, user can initiate cells balancing task. During task, display will turn off,
breath light will turn on within 20s, if no operation is detected。
battery capacity percentage, temperature BattGo mark will only show when smart battery is connected,

This battery checker is suitable for :LiHv (1-8S) / LiPo (1-8S) / LiFe(1-8S) / Lilon (1-8S) / NiMH/Cd(1-10S);
this battery checker is suitable for the connection with balance port of battery, While connect to
the battery checker, negative electrode of the balance port must start from“BAT“- . Reverse
protection circuit is inside the BG-8S, no damage will cause to BG-8S while connect reversely.
BG-8S is designed for RC areas, please don’t use this on other purpose.
No usage in long time, please disconnect BG-8S with your battery to avoid over discharging your
battery.

Specifications